Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- ########################creality_cr10_pla_#2####################################
- [general]
- version = 4
- name = PLA #2
- definition = fdmprinter
- [metadata]
- type = quality_changes
- setting_version = 4
- quality_type = draft
- [values]
- adaptive_layer_height_enabled = True
- adhesion_type = raft
- layer_height_0 = 0.26
- material_bed_temperature = 50
- support_enable = True
- #####################fdmextruder_#2_pla_#2######################################
- [general]
- version = 4
- name = PLA #2
- definition = fdmprinter
- [metadata]
- type = quality_changes
- setting_version = 4
- position = 0
- quality_type = draft
- [values]
- acceleration_print = 450
- acceleration_travel = 4500
- bottom_layers = 6
- infill_sparse_density = 15
- infill_sparse_thickness = 0.2
- infill_wipe_dist = 0.2
- ironing_enabled = True
- jerk_print = 10
- jerk_travel = 20
- material_print_temperature = 200
- material_print_temperature_layer_0 = 200
- optimize_wall_printing_order = True
- retract_at_layer_change = True
- retraction_amount = 7
- retraction_extra_prime_amount = 0.005
- retraction_hop = 0.8
- retraction_hop_enabled = True
- retraction_hop_only_when_collides = True
- retraction_min_travel = 0.4
- retraction_speed = 60
- skirt_line_count = 2
- speed_layer_0 = =speed_print * 30 / 60
- speed_print = 55
- speed_print_layer_0 = 20
- speed_topbottom = =speed_print / 2
- speed_travel_layer_0 = 30
- speed_wall = =speed_print / 2
- support_angle = 80
- support_infill_rate = 5
- top_bottom_pattern = zigzag
- top_bottom_thickness = 0.6
- top_layers = 6
- wall_thickness = 0.8
Add Comment
Please, Sign In to add comment
