激光测距挖矿v2 自动停止

local laser = peripheral.find("warpdriveLaser")
local mininglasers = {}
local sides = peripheral.getNames()
local zeroBlockCount = 0

for _, side in pairs(sides) do
  if peripheral.getType(side) == "warpdriveMiningLaser" then
    table.insert(mininglasers, peripheral.wrap(side))
  end
end

laser.beamFrequency(1420)

if not laser then
  print("No warpdriveLaser detected")
  os.exit()
end

if #mininglasers == 0 then
  print("No warpdriveMiningLaser detected")
  os.exit()
end

print("Press the 'M' key to emit a laser scan and start the mining lasers with calculated layer offset.")

-- Loop to wait for key events
while true do
  -- Wait for a key event
  local event, key = os.pullEvent("key")

  -- Check if the "M" key was pressed (key code 50)
  if key == 50 then
    -- Get the laser's own position
    local _, laserY, _ = laser.getLocalPosition()

    -- Emit a laser scan in the Y- direction (0, -1, 0)
    laser.emitBeam(0, -1, 0)

    -- Get the scan result
    local _, _, targetY = laser.getScanResult()

    -- Calculate the layerOffset
    local mineTarget = laserY - targetY - 1

    -- Print the target
    print("Target is: " .. mineTarget .. " blocks below")

    -- Configure the mining lasers to use the mineTarget as the layerOffset
    for _, mininglaser in pairs(mininglasers) do
      mininglaser.offset(mineTarget)
      mininglaser.enable(true)
    end

    repeat
      local areActive = false
      for _, mininglaser in pairs(mininglasers) do
        local _, isActive, _, _, _, total = mininglaser.state()

        if total == 0 then
          zeroBlockCount = zeroBlockCount + 1
        else
          zeroBlockCount = 0
        end

        if zeroBlockCount >= 3 then
          print("3 consecutive layers with 0 total blocks detected. Stopping mining.")
          for _, mininglaser in pairs(mininglasers) do
               shell.run("stop")
          end
          break
        end

        if isActive then
          areActive = true
        end
      end
      os.sleep(1)
    until not areActive or zeroBlockCount >= 3

    -- Reset zeroBlockCount for the next mining session
    zeroBlockCount = 0
  end
end