Sensor Initialization rev_02

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: Sensor Initialization
    - Source Code NOT compiled for: Arduino Uno
    - Source Code created on: 2024-08-14 22:57:06

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* Write a python code that can be used to create */
    /* Camera Initialization and Ladle calculations */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <DHT.h>    //https://github.com/adafruit/DHT-sensor-library

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t ontappa_DHT11_DOUT_PIN_D2 = 2;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
// Initialize the DHT sensor object with the pin number and sensor type
#define DHTTYPE DHT11 // Define the type of DHT sensor
DHT dht(ontappa_DHT11_DOUT_PIN_D2, DHTTYPE); // Create an instance of the DHT class

// Placeholder for camera initialization
void initializeCamera() {
    // Code to initialize the camera would go here
    Serial.println(F("Camera initialized.")); // Print confirmation message
}

// Placeholder for ladle calculations
void performLadleCalculations() {
    // Code for ladle calculations would go here
    Serial.println(F("Ladle calculations performed.")); // Print confirmation message
}

void setup(void)
{
    // Start the serial communication
    Serial.begin(9600); // Initialize serial communication at 9600 baud rate

    // Initialize the DHT sensor
    dht.begin(); // Start the DHT sensor

    // Initialize the camera
    initializeCamera(); // Call the camera initialization function
}

void loop(void)
{
    // Wait a few seconds between measurements
    delay(2000); // Delay for 2 seconds

    // Read temperature as Celsius
    float temperature = dht.readTemperature(); // Read temperature in Celsius

    // Check if any reads failed and exit early (to try again).
    if (isnan(temperature)) {
        Serial.println(F("Failed to read temperature from DHT sensor!")); // Print error message
        return; // Exit the loop if reading failed
    }

    // Read humidity
    float humidity = dht.readHumidity(); // Read humidity

    // Check if any reads failed and exit early (to try again).
    if (isnan(humidity)) {
        Serial.println(F("Failed to read humidity from DHT sensor!")); // Print error message
        return; // Exit the loop if reading failed
    }

    // Print the results to the Serial Monitor
    Serial.print(F("Temperature: "));
    Serial.print(temperature);
    Serial.println(F("°C"));

    Serial.print(F("Humidity: "));
    Serial.print(humidity);
    Serial.println(F("%"));

    // Perform ladle calculations
    performLadleCalculations(); // Call the ladle calculations function
}

/* END CODE */