**Sensor Control** rev_01

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: **Sensor Control**
    - Source Code NOT compiled for: Arduino Uno
    - Source Code created on: 2024-11-15 13:19:30

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* The project aims to develop an Arduino-based */
    /* system that utilizes connected components for */
    /* automation, focusing on efficient resource */
    /* management and seamless integration of sensors and */
    /* actuators. */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <Wire.h>
#include <Servo.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/****** GLOBAL VARIABLES *****/
// Example global variables for sensor and actuator management
Servo myServo; // Create a Servo object
int sensorValue = 0; // Variable to store sensor value

void setup(void)
{
    // Initialize serial communication for debugging
    Serial.begin(9600);

    // Initialize the servo on pin 9
    myServo.attach(9);

    // Initialize I2C communication
    Wire.begin();
}

void loop(void)
{
    // Read sensor value (example: from an analog sensor)
    sensorValue = analogRead(A0);

    // Print the sensor value to the serial monitor
    Serial.print("Sensor Value: ");
    Serial.println(sensorValue);

    // Map the sensor value to servo position (0 to 180 degrees)
    int servoPosition = map(sensorValue, 0, 1023, 0, 180);

    // Move the servo to the mapped position
    myServo.write(servoPosition);

    // Wait for a short period before the next loop iteration
    delay(100);
}

/* END CODE */