Scanner rev_104

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: Scanner
    - Source Code compiled for: Arduino Mega
    - Source Code created on: 2023-11-02 20:00:04
    - Source Code generated by: AlexWind

********* Pleasedontcode.com **********/
/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <SoftwareSerial.h>

/****** SYSTEM REQUIREMENT 1 *****/
/* Use seril and dsfgds to pass TX and RX data */
/* between them. */

/****** SYSTEM REQUIREMENT 2 *****/
/* Seril TX data is passed to RX dsfgds. dsfgds TX */
/* data is passed to RX Seril. */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF Software Serial *****/
const uint8_t seril_PIN_SERIAL_TX_A0 = A0;
const uint8_t seril_PIN_SERIAL_RX_D6 = 6;
const uint8_t dsfgds_PIN_SERIAL_TX_A1 = A1;
const uint8_t dsfgds_PIN_SERIAL_RX_A3 = A3;
SoftwareSerial seril(seril_PIN_SERIAL_RX_D6, seril_PIN_SERIAL_TX_A0);
SoftwareSerial dsfgds(dsfgds_PIN_SERIAL_RX_A3, dsfgds_PIN_SERIAL_TX_A1);

void setup(void)
{
  // put your setup code here, to run once:
  seril.begin(9600); // Set baud rate to 9600 for seril
  dsfgds.begin(9600); // Set baud rate to 9600 for dsfgds
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  if (seril.available()) {
    char data = seril.read();
    dsfgds.write(data);
  }

  if (dsfgds.available()) {
    char data = dsfgds.read();
    seril.write(data);
  }
}