Temperature Control rev_01

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: Temperature Control
    - Source Code NOT compiled for: Arduino Uno
    - Source Code created on: 2024-05-04 08:22:30

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* Turn light on off */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <DS18B20.h>
#include <MCP23017.h>

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t Test_DS18B20_DQ_PIN_D2 = 2;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
DS18B20 ds(Test_DS18B20_DQ_PIN_D2);
MCP23017 ioExpander;

void setup(void)
{
    // Initialize MCP23017
    ioExpander.begin();

    // Set pin modes for MCP23017
    ioExpander.pinMode(8, INPUT_PULLUP); // Replace pin numbers as required
    ioExpander.pinMode(9, INPUT_PULLUP);
    ioExpander.pinMode(0, OUTPUT);
    ioExpander.pinMode(1, OUTPUT);

    // Set initial digital outputs
    ioExpander.digitalWrite(0, LOW);
    ioExpander.digitalWrite(1, LOW);
}

void loop(void)
{
    // Check input pin value and update output pins on the MCP23017
    ioExpander.digitalWrite(0, !ds.getTempC());  // Placeholder logic - change as needed
    ioExpander.digitalWrite(1, ds.getTempC());   // Placeholder logic - change as needed
}

/* END CODE */