LED Control rev_11

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: LED Control
    - Source Code NOT compiled for: Arduino Uno
    - Source Code created on: 2025-02-08 01:24:29

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* say hello on serial monitor */
/****** SYSTEM REQUIREMENT 2 *****/
    /* Implement a feature to send a greeting message to */
    /* the Serial Monitor when the Arduino initializes, */
    /* ensuring the message is clear and visible for */
    /* debugging purposes. */
/****** END SYSTEM REQUIREMENTS *****/


/********* User code review feedback **********
#### Feedback 1 ####
- Review the code with following data: "void setup() {
    Serial.
begin(9600); // Initialize serial communication at 9600 bps

// Send a greeting message to the Serial Monitor
    Serial.prin
tln("Hello! Arduino has initialized successfully."); // Greeting
 message
}

void loop() {
    // Main code r
********* User code review feedback **********/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h> // Include Arduino library for basic functions

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void); // Function prototype for updateOutputs

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t myLED_LED_PIN_D2 = 2;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool myLED_LED_PIN_D2_rawData = 0;

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float myLED_LED_PIN_D2_phyData = 0.0;

void setup(void)
{
    // put your setup code here, to run once:
    Serial.begin(9600); // Initialize serial communication at 9600 baud rate
    pinMode(myLED_LED_PIN_D2, OUTPUT); // Set the LED pin as output

    // Send greeting message to Serial Monitor
    Serial.println("Hello! Arduino has initialized successfully."); // Greeting message
}

void loop(void)
{
    // put your main code here, to run repeatedly:
    updateOutputs(); // Refresh output data
}

void updateOutputs(void)
{
    digitalWrite(myLED_LED_PIN_D2, myLED_LED_PIN_D2_rawData); // Update the LED state
}

/* END CODE */