Scanner rev_129

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: Scanner
    - Source Code compiled for: Arduino Uno
    - Source Code created on: 2023-11-12 17:06:49
    - Source Code generated by: AlexWind

********* Pleasedontcode.com **********/

/********* User code review feedback **********
#### Feedback 1 ####
- complete the code
********* User code review feedback **********/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <SoftwareSerial.h>

/****** SYSTEM REQUIREMENT 1 *****/
/* get hc05 signal and change PWM signal reducing */
/* percentage if receiving DOWN data or increasing */
/* percentage if receiving UP data. */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t activation_PIN_D3 = 3;

/***** DEFINITION OF Software Serial *****/
const uint8_t bluetooth_HC05_mySerial_PIN_SERIAL_TX_A0 = A0;
const uint8_t bluetooth_HC05_mySerial_PIN_SERIAL_RX_A1 = A1;
SoftwareSerial bluetooth_HC05_mySerial(bluetooth_HC05_mySerial_PIN_SERIAL_RX_A1, bluetooth_HC05_mySerial_PIN_SERIAL_TX_A0);

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(activation_PIN_D3, OUTPUT);
  bluetooth_HC05_mySerial.begin(9600);
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  // Read data from HC05 module
  if (bluetooth_HC05_mySerial.available()) {
    char data = bluetooth_HC05_mySerial.read();
    // Check if data is 'U' for UP or 'D' for DOWN
    if (data == 'U') {
      // Increase PWM signal percentage
      // Add your code here
      analogWrite(activation_PIN_D3, 200); // Example: Set PWM signal to 80% duty cycle
    } else if (data == 'D') {
      // Decrease PWM signal percentage
      // Add your code here
      analogWrite(activation_PIN_D3, 100); // Example: Set PWM signal to 40% duty cycle
    }
  }
}