LED Toggle rev_01

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: LED Toggle
    - Source Code NOT compiled for: Arduino Uno
    - Source Code created on: 2024-08-24 15:28:35

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* The project shall implement LED control on pin D2, */
    /* requiring continuous monitoring and updating of */
    /* its state using raw data. The setup function must */
    /* configure the pin for output to enable LED */
    /* functionality. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(); // Function prototype for updating outputs

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t led_LED_PIN_D2 = 2; // Pin for LED control

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool led_LED_PIN_D2_rawData = 0; // Initial state of the LED (off)

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float led_LED_PIN_D2_phyData = 0.0; // Placeholder for transformed data

// Instantiate any necessary objects here (if required by libraries)
// Currently, no additional libraries are included that require instantiation

void setup(void)
{
    // Configure pin D2 as an output to enable LED functionality
    pinMode(led_LED_PIN_D2, OUTPUT); // Set pin D2 as an output
}

void loop(void)
{
    // Continuous monitoring and updating of LED state
    led_LED_PIN_D2_rawData = !led_LED_PIN_D2_rawData; // Toggle LED state for demonstration
    updateOutputs(); // Refresh output data based on the raw data
    delay(1000); // Delay for 1 second to observe LED state change
}

void updateOutputs()
{
    // Update LED state based on raw data
    digitalWrite(led_LED_PIN_D2, led_LED_PIN_D2_rawData); // Write the current state to the LED
}

/* END CODE */