modem_at_command_bluetooth_old

#define RXD2 17
#define TXD2 16
#define PKEY 5
#define RST 4
unsigned long cur_time, old_time;
#define TINY_GSM_MODEM_SIM7600
#include <TinyGsmClient.h>
#define SerialMon Serial
#define TINY_GSM_DEBUG SerialMon
#define SerialAT Serial2


#ifdef DUMP_AT_COMMANDS
  #include <StreamDebugger.h>
  StreamDebugger debugger(SerialAT, SerialMon);
  TinyGsm modem(debugger);
#else
  TinyGsm modem(SerialAT);
#endif

bool hold = 0;

#include "BluetoothSerial.h"

#if !defined(CONFIG_BT_ENABLED) || !defined(CONFIG_BLUEDROID_ENABLED)
#error Bluetooth is not enabled! Please run `make menuconfig` to and enable it
#endif

BluetoothSerial SerialBT;

void setup() {
  // put your setup code here, to run once:
  SerialMon.begin(115200);
  SerialAT.begin(9600, SERIAL_8N1, RXD2, TXD2);
  delay(1000);
  Serial.println("test at mulai");
  pinMode(RST, OUTPUT);
  //pinMode(PKEY, OUTPUT);
  //digitalWrite(PKEY, LOW);
  digitalWrite(RST, HIGH);delay(1000);
  digitalWrite(RST, LOW);delay(1000);
  digitalWrite(RST, HIGH);delay(1000);
  delay(1000);
  wRespon(15000);
  /*SerialAT.println("AT");
  wRespon(1000);
  SerialAT.println("AT+IPREX?");
  wRespon(1000);
  SerialAT.println("AT+IPREX=9600");
  wRespon(1000);
  SerialAT.println("AT&W");
  wRespon(1000);
  SerialAT.begin(9600, SERIAL_8N1, RXD2, TXD2);
  */
}

void loop() {
  // put your main code here, to run repeatedly:
  Serial.println("SEND AT");
  send_at("AT");
  send_at("ATI");
  send_at("AT+IPR?");
  send_at("AT+CPIN?");
  send_at("AT+CPIN?");
  send_at("AT+CSQ");
  send_at("AT+CREG?");
  send_at("AT+CPSI?");


}

void send_at(char *_command) {
  SerialAT.println(_command);
  wRespon(1000);
}

void wRespon(long waktu){
  cur_time = millis();
  old_time = cur_time;
  while(cur_time - old_time < waktu ){
    cur_time = millis();
    while(SerialAT.available()>0){
      //Serial.print(SerialAT.readString());
      SerialBT.println(SerialAT.readString());
    }
  }
}