GPSTime rev_111

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: GPSTime
    - Source Code compiled for: Arduino Uno
    - Source Code created on: 2023-11-20 15:18:36
    - Source Code generated by: Francesco Alessandro

********* Pleasedontcode.com **********/
/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <SoftwareSerial.h>
#include <Wire.h>
#include <MicroNMEA.h>
#include <LiquidCrystal_I2C.h>

/****** SYSTEM REQUIREMENT 1 *****/
/* Reads hour, minutes and seconds from GPS */
/* module using MicroNMEA library. Display hours, */
/* minutes and seconds on 6x 7seg LED display. When */
/* mins and secs are 00 00, contact closure for about */
/* 1 sec. */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t contactClosure_PIN_D7 = 7;

/***** DEFINITION OF Software Serial *****/
const uint8_t NEO_6M_GPS_module_PIN_SERIAL_TX_A0 = A0;
const uint8_t NEO_6M_GPS_module_PIN_SERIAL_RX_A1 = A1;
SoftwareSerial NEO_6M_GPS_module(NEO_6M_GPS_module_PIN_SERIAL_RX_A1, NEO_6M_GPS_module_PIN_SERIAL_TX_A0);

/***** DEFINITION OF I2C PINS *****/
const uint8_t lcd_LCD1602I2C_I2C_SLAVE_ADDRESS = 0x27;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
LiquidCrystal_I2C lcd(lcd_LCD1602I2C_I2C_SLAVE_ADDRESS, 16, 2);

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(contactClosure_PIN_D7, OUTPUT);

  NEO_6M_GPS_module.begin(9600);
  lcd.begin(16, 2);

  lcd.setCursor(0, 0);
  lcd.print("GPS Time:");

  lcd.setCursor(0, 1);
  lcd.print("00:00:00");
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  if (NEO_6M_GPS_module.available())
  {
    char c = NEO_6M_GPS_module.read();
    // Process the received character from GPS module here
  }
}