LinearRailSlide rev_77

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: LinearRailSlide
    - Source Code compiled for: Arduino Uno
    - Source Code created on: 2023-11-29 22:17:31
    - Source Code generated by: Francesco Alessandro

********* Pleasedontcode.com **********/
/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <Stepper.h>

/****** SYSTEM REQUIREMENT 1 *****/
/* A stepper motor drives a 200 mm length linear rail */
/* slide. The motor performs 100 steps/revolution. */
/* Step per mm of Lead screw is 10mm. */
/****** SYSTEM REQUIREMENT 2 *****/
/* Perform a complete continuous travel of 200mm from */
/* right to left in 12 hours. Then go back from left */
/* to right again in 12 hours. */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t STEPPER_PIN_1_PIN_D2 = 2;
const uint8_t STEPPER_PIN_2_PIN_D3 = 3;
const uint8_t STEPPER_PIN_3_PIN_D4 = 4;
const uint8_t STEPPER_PIN_4_PIN_D5 = 5;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
const int stepsPerRevolution = 100;
Stepper myStepper(stepsPerRevolution, STEPPER_PIN_1_PIN_D2, STEPPER_PIN_2_PIN_D3, STEPPER_PIN_3_PIN_D4, STEPPER_PIN_4_PIN_D5);

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(STEPPER_PIN_1_PIN_D2, OUTPUT);
  pinMode(STEPPER_PIN_2_PIN_D3, OUTPUT);
  pinMode(STEPPER_PIN_3_PIN_D4, OUTPUT);
  pinMode(STEPPER_PIN_4_PIN_D5, OUTPUT);

  myStepper.setSpeed(100);
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  myStepper.step(stepsPerRevolution);
  delay(60000); // Delay for 1 minute
}