########################creality_cr10_pla_#2####################################
[general]
version = 4
name = PLA #2
definition = fdmprinter

[metadata]
type = quality_changes
setting_version = 4
quality_type = draft

[values]
adaptive_layer_height_enabled = True
adhesion_type = raft
layer_height_0 = 0.26
material_bed_temperature = 50
support_enable = True

#####################fdmextruder_#2_pla_#2######################################
[general]
version = 4
name = PLA #2
definition = fdmprinter

[metadata]
type = quality_changes
setting_version = 4
position = 0
quality_type = draft

[values]
acceleration_print = 450
acceleration_travel = 4500
bottom_layers = 6
infill_sparse_density = 15
infill_sparse_thickness = 0.2
infill_wipe_dist = 0.2
ironing_enabled = True
jerk_print = 10
jerk_travel = 20
material_print_temperature = 200
material_print_temperature_layer_0 = 200
optimize_wall_printing_order = True
retract_at_layer_change = True
retraction_amount = 7
retraction_extra_prime_amount = 0.005
retraction_hop = 0.8
retraction_hop_enabled = True
retraction_hop_only_when_collides = True
retraction_min_travel = 0.4
retraction_speed = 60
skirt_line_count = 2
speed_layer_0 = =speed_print * 30 / 60
speed_print = 55
speed_print_layer_0 = 20
speed_topbottom = =speed_print / 2
speed_travel_layer_0 = 30
speed_wall = =speed_print / 2
support_angle = 80
support_infill_rate = 5
top_bottom_pattern = zigzag
top_bottom_thickness = 0.6
top_layers = 6
wall_thickness = 0.8